ELGO AP-00 Magnetic Tape Cover Profile
Aluminium Cover Profile for 10 mm Magnetic Tapes
- Alternative to conventional cover tape
- Aluminum profil (20 mm wide, 2 mm thick)
- 10 mm wide groove for the magnetic tanpe
- Available Lengths 1 or 2 meters
You are here:
Accessories for measuring systems
8 products
ELGO Elastomer-based magnetic-rings
Radial and axial versions in different diameters
- Incremental or absolute magnetic rings
- In radial (MRR) or axial (MRA) design
- Thanks to protection class IP68 predestined for outdoor use
- Resistant to thermal, chemical and mechanical influences
ELGO end caps
Optimal protection for magnetic tapes
- Optimale protection against the peel off of the magnetic tape / cover tape
- Reduce the hazard of injury by sharp edges
ELGO Guide Carriage
Suitable for Guide Rail and various Measuring Systems
- Made of special sliding plastic
- For the assembly of sensors
- Different sizes available
ELGO Guide rail
Aluminium Guide Rail for Magnetic Tapes
- Aluminium guide rail, 25 mm wide, 6 mm high
- For 10 and 20 mm magnetic tape
- Slot on both sides (1 x 10 mm, 1 x 20 mm) for magnetic tape
- Lengths up to 2 meters
ELGO Magnetic rings hard ferrite
For rotative measurements
- Interpolation up to zu 22.800 pulses/revolution
- Direct assembly on axes possible (e.g. motor shaft)
- Contactless and wear-free measuring principle
- Applicable in roughest environments (IP67)
ELGO Magnetic Tape MB20 | AB20
Incremental or absolute coded
magnetic tape layoutA the cover tape is used for the mechanical protection of the magnetic tape and is glued onto the magnetic plastictape after installation
ELGO PNO SSI – PROFIBUS Converter
Simple conversion from SSI to PROFIBUS
- Up to 1,200 m cable length
- Transmission rate up to 12 MBaud
- Easy assembly due to assembly slots
- Even for older ELGO devices